I have just installed a new HD on my gateway laptop, before doing so i
have coppied the NIC card driver from the old HD located at:
C:\WINDOWS\system32\drivers\MN120-51.  Then i tried moving it to the
same location in the new HD.  All i have done was copy the file into

Hi, i'm attempting to setup NT server 4 and can't get past a stage
where you hit F6 and it comes up asking for "mass storage drivers" and
"to specify additional drivers hit s" etc, does anyone know what
drivers it is asking for? there is no SCSI card in the system or

I have inherited a new nt 4.0 network with 2 servers. One of the servers I
can connect to over TCP/IP with new xp computers I am installing on the
network. the other server requires netbeui to be installed on the new xp-pcs
to gain access to the shared files. Both servers have ...

When I install Windows NT 4.0 (Server & Workstation), I chosen to use the 3
floppies at reboot. But after specifying the mass storage device, the
computer stops with "Please wait..." below. Then my computer reboots
itself!!!!

I have an NT 4 server that has functioned well with little attention for
years.
Last week it was very slow and on reboot it failed.
The failure was during the OS loader phase.  (OS Loader V 4.01) I got 8 dots

Have an old Windows NT domain with no BDC.  Eventually will disband the
domain (rather than migrate to Windows 2003)  however, in the interim, I
would like to set up a BDC.  I run the install for Windows NT Server and
choose BDC as the configuration.  However, when I get to the ...