Hi, I installed XP on a machine,(C driver) then,
I tried to install 2000 Server over XP. The XP did not allow to install NT
Server, as it is an older version. So I have to install NT directely from
start on the NT CD. The NT installation (on driver D) was successful, but

I'm new to NT 4.
I am aware that NT4 has a 4GB install limitation.
I have a 40GB hard drive on a test server and installed SBS Backoffice 4.5
which includes NT4, using a partition size of 4GB for the install. Obviously,

I have found very limited first-hand information on the net about  
installing/running  NT 4.0 on the relatively new system. I can report some  
success and I hope, the information isn't redundant.
My old configuration was:

Question:
1. How can I transfer the SAM & shares from one NT 4.0 Server to a different
NT 4.0 server hardware, when the new hardware is not on the network?
Note:

  I have Netfinity server 5600 with 4 SCSI disk. I want to format the
SCSI disc and install NT again. How do i go ahead.
Please Help.

I had the mis-fortune of dealing devices not natively supported by NT 4.
how would one find conflicting resources and free IRQ, memory address to
configure a network device on NT 4 SP4 or 5?
In Winnt or XP, one can look at system info, or sys mgmt device manager.  In

I put in a battery into my NT40 server after having error saying CMOS
Battery Failed, loading defaults, Press F1, etc.
It continued to have same error, so I figured that battery was weak,
after sitting for 3 months in unused computer.  Bought a new 2032 and

I am attempting to install NT Server 4.0 on an IBM xSeries 206 server
with 3.06 GHz Pentium 4, 512Mb memory and 2 x 80 Gb SATA drives. These
are setup as one logical drive using the built-in IBM SATA Raid
controller (Raid 1).

I've got a Win 2K SP4 system currently running a Matrox P650 AGP (4X) video
card. That card is great for my graphic arts work, but it hasn't got the
oomph to run modern games. I was wondering if there were any way to run a
second video card from one of the PCI slots? Ideal would be ...

I put in a new 10/100 NIC card in my NT4.0 server and when restarting,
I get a continual hang on "Updating ESCD"......  
What happened, and what can I do to get by or fix the problem?
Any suggestions are welcomed BIGTIME!

  I ave problems with installation WinNT40 on xSeries226 IBM server
....    After booting with WinNT40 CD everything goes fine (loading
drivers) but   after a wile I got verical lines on my screen and nothing
goes on after that....